Heavy Mold Cleaning of Marble, Traverting & Slate Showers

In marble, travertine, slate and other natural stone showers where mold is heavy and obviously visible, the removal of mold stains can be accomplished quite simply.  The following is our recommended method.  If after following these simple steps satisfactory results are not achieved, please contact Marblelife Customer Care for free assistance in accomplishing your desired results.

 

Supplies Needed:

 

Step 1 – Spay, Scrub & Soak

Spray ample amount of Marblelife Mold & Mildew Stain Remover directly on the areas of visible mold adequate to saturate the stone and grout.  Include the surrounding area for thorough coverage.  With a soft brush, scrub the affected area to loosen the top layer of mold and allow the Mold & Mildew Stain Remover to reach the under layers of mold.  Reapply Mold & Mildew Stain Remover if needed so that the affected area is well saturated and allow to soak for about 10 minutes.

 

Step 2 – Scrub & Rinse

After doing Step 1 and allowing to soak for 10 minutes, scrub one more time and rinse with clean water using the cup, container or spray nozzle.  Survey the results and repeat if needed until mold is no longer visible.

 

Step 3 “Optional” – Spray, Soak & Rinse

To assure the shower stays mold free and that underlying mold stains have been dealt with, spray Mold & Mildew Stain Remover to affected area one last time and allow to soak.  Then after 10 minutes, rinse with clean water and enjoy your fresh clean shower.

 

If for any reason to don’t see the desired results, contact Marblelife Customer Care for free assistance in reaching your desired results.

 

Marblelife… Helping Make Your Life Easier.